Micro Effects Dimmer LED Lighting Control Strobe Flash Blink 5 12 24 volt MED1-B

Description

The P/N MED1 Micro Effects Dimmer provides dimming, multimode effects, and on / off control of 5 – 24 volt DC LED lights.
The unit features a simple tactile three button interface; Light, Speed, and Mode.
The variety of effects combined with the simplicity of use makes this a great control for low complexity projects.
The Light button
is used in static mode for dimming. Note the Static (0 mode) dimming function is between effects #8 and #1 when sequencing through the modes.
The Speed (On/Off) button
provides ten speed levels for the effects modes and is also used to turn the unit off when it is held longer than 3 seconds.
The Mode button
provides eight dynamic effects, and the Static (0 mode) between effects #8 and #1.
Mode effects patterns
0) Static mode for dimming
1) Up / Down – ramp up on ramp down off – repeat
5) Blinking – long on
2) Up / Down – flame flicker – always on
6) Flash - burst of pulses (emergency vehicle light)
3) Strobe – fast
7) Strobe – slow (beacon light)
4) Blinking – long off
8) Up / Down varying brightness – brief off – repeat
The MED1 body measures a nominal 1.4” length, 0.6” wide and 0.2” thickness.
Each of the connector cables extends from the body 5.5”.
The overall end to end length of the entire body and cable assembly is 13.0” Max.
The unit’s body is sleeved in black and the cables are molded in black PVC.
Well suited for various LED lighting applications such as:
Flex Strip accent lighting
Promotional LED signs
Specialized décor lighting
F/X prop and costume lighting
Stage Lighting
Theatrical effects lighting
POS Point Of Sale displays
Architectural accent lighting
The MED1 operates with 5, 9, 12 or 24 volt DC lighting systems and can switch a maximum of 4 amps. The unit provides up to 20 watts of lighting control when using a 5 volt system, 48 watts on 12 volt or up to 96 watts of lighting on a 24 volt system.
The control may be operated from a 9 volt battery for portable applications, it is recommended to limit the LED light load current to 100ma for battery life.
The MED1 is equipped with a barrel connector type DC power jack and plug. The connectors are of the 5.5mm x 2.1mm size with a positive center connection. The body of the MED1 control is of a small size with a low profile. The MED1 body measures a nominal 1.4” length, 0.6” wide and 0.2” thickness.
Each of the connector cables extends from the body 5.5”.
The overall end to end length of the entire body and cable assembly is 13.0” Max.
The unit’s body is sleeved in black and the cables are molded in black PVC.